Fanuc Power Mate i-D/H Maintenance Manual

APPENDIX
B63175EN/03
D. MEMORY CARD OPERATORS
MANUAL
535
The PCMCIA card interface in the FANUC Power Mate iD/H main unit
can be used for data input/output with flash ATA cards (for operation on
5 V).
Model Series Edition
Power Mate iD 88E0 09 or later
System software
88F0 08 or later
Power Mate iH
88F1 01 or later
Boot software Power Mate iD/H 881I 05 or later
The flash ATA card must satisfy the following requirements related to the
standards and shapes.
Note that not all flash ATA cards can operate on the Power Mate iD/H.
1) Card standards
PCMCIA (Personal Computer Memory Card International
Association)
PC Card standard Release2.1, PCMCIA PC Card ATA Release 1.02
2) Card shapes
PCMCIA TYPE IXTYPE II
3) Card operation mode
PCATA specification
4) Card operating voltage
Both 5 V (D) and 5/3.3 V (automaticswitching) type flash ATA cards
can be used.
D.8
ATA CARD
D.8.1
Overview
D.8.2
Corresponding
Software Versions
D.8.3
Flash ATA Card
Specification

Leave a Reply

Your email address will not be published. Required fields are marked *