Fanuc Power Mate i-D/H Maintenance Manual

APPENDIX
D. MEMORY CARD OPERATORS
MANUAL
B63175EN/03
536
Listed below are the flash ATA cards that have proved to be operable on
the Power Mate iD/H as of August 2001. (All of these cards are of a 5/3.3
V automaticswitching type).
1) Flash ATA cards used for data input/output (saving and restoring data)
Manufacture Model Size Remarks
(C) HITACHI
HB286008A3 8MB
Production has
HB286015A3 15MB
been discontinued.
HB286030A3 30MB
HB286045A3 45MB
HB289016A4 16MB
Mass production is
HB289032A4 32MB
under way.
HB289048A4 48MB
(C) MATSUSHITA
BN012AB 12MB
BN020AB 20MB
BN040AB 40MB
SanDisk
SDP3B20 20MB
Production has
SDP3B40 40MB
been discontinued.
NOTE
1 We do not guarantee that any card not listed above will
operate on the Power Mate iD/H.
2 The flash ATA cards listed above are of a 5/3.3 V
automaticswitching type.
3 No 3.3 Vonly type can be used on the Power Mate iD/H.
4 A flash ATA card, even if listed above, may become
inoperable on the Power Mate iD/H if the manufacturer
changes its specification.
NOTE
If a flash ATA card is used on any Power Mate CNC other
the Power Mate iD/H, it is likely that the CNC control
section or flash ATA card may electrically break down. The
flash ATA card can be physically inserted into the PCMCIA
card interface of a Power Mate CNC other than the Power
Mate iD/H. Be very careful to avoid inserting a flash ATA
card into the PCMCIA card interface of any Power Mate
CNC other than the Power Mate iD/H accidentally.
D.8.4
Flash ATA Cards That
Have Proved to Be
Operable on the Power
Mate iD/H

Leave a Reply

Your email address will not be published. Required fields are marked *