Fanuc Power Mate i-D/H Maintenance Manual

APPENDIX
B63175EN/03
D. MEMORY CARD OPERATORS
MANUAL
539
Several types of SRAM memory cards and flash ATA cards can be used
on the PCMCIA interface of the LCD with touch panel supporting the
display link.
NOTE
1 The functions that can be used on the PCMCIA card
interface of the LCD with touch panel differ from those
usable on the PCMCIA card interface of the CNC main unit.
2 The cards that can be used on the PCMCIA card interface
of the LCD with touch panel are not necessarily the same
as those usable on the PCMCIA card interface of the CNC
main unit.
3 Some files, such as a touch panel screen data file, cannot
be transferred with this interface.
The software versions listed below are necessary.
Series Edition
88E0 13 or later
System software
88F1 05 or later
Boot software 881I 09 or later
The flash ATA card must satisfy the following requirements related to the
standards and shapes.
Note that not all flash ATA cards can operate on the Power Mate
iD/H.
1) Card standards
PCMCIA (Personal Computer Memory Card International
Association)
PC Card standard Release2.1, PCMCIA PC Card ATA Release 1.02
2) Card shapes
PCMCIA TYPE IXTYPE II
3) Card operation mode
PCATA specification
4) Card operating voltage
Both 5 V (D) and 5/3.3 V (automaticswitching) type flash ATA cards
can be used.
D.9
MEMORY CARDS
USABLE ON THE
LCD WITH TOUCH
PANEL
D.9.1
Overview
D.9.2
Corresponding
Software Versions
D.9.3
Flash ATA Card
Specification

Leave a Reply

Your email address will not be published. Required fields are marked *