Fanuc Power Mate i-D/H Maintenance Manual

APPENDIX
B63175EN/03
D. MEMORY CARD OPERATORS
MANUAL
541
NOTE
1 We do not guarantee that any card not listed above will
operate on the LCD with touch panel.
2 The flash ATA cards listed above are of a 5/3.3 V
automaticswitching type.
3 No 3.3 Vonly type can be used on the LCD with touch
panel.
4 A flash ATA card, even if listed above, may become
inoperable on the LCD with touch panel if the manufacturer
changes its specification.
5 The flash memory card cannot be used.
After parameter No. 20 is set to 7, operating [PUNCH] or [READ] on each
screen causes the following data to be output or input through the
PCMCIA card interface of the LCD with touch panel.
Input/output data Input/output operation screen
Programs Program screen or ALL I/O screen
Parameters Parameter screen or ALL I/O screen
Tool compensation data Tool compensation screen or ALL I/O screen
Custom macro variables Macro variable display screen or ALL I/O screen
Pitch error compensation
data
Pitch error compensation screen or ALL I/O screen
Periodic maintenance
data
Periodic maintenance screen
Maintenance information Maintenance information screen
Operation history Operation history screen
PMC parameters PMC I/O screen
Ladder programs PMC I/O screen
I/O Link slave β amp
parameter
Power Mate CNC manager parameter screen
In addition to data input/output, file directory display, search, and
deletion can be made on memory card lists on the ALL I/O screen, PMC
I/O screen, and program screen.
Refer to the connection manual (function), operation manual, and this
manual for details of explanations about how to perform data
input/output.
S FANUC Power Mate iD/H CONNECTION MANUAL (FUNCTION)
B63173EN1
S FANUC Power Mate iD/H OPERATORS MANUAL
B63174EN
D.9.5
Supported Functions

Leave a Reply

Your email address will not be published. Required fields are marked *