Fanuc Power Mate i-D/H Maintenance Manual

F. SETTING/DISPLAY/MAINTENANCE
USING THE MAIN UNIT OF
THE Power Mate i
B63175EN/03
APPENDIX
556
Primary Explanation
Tertiary and
subsequent
operation
Secondary
Confirmation of setting
Displaying selected data
D The item selected when 1 or 2 is selected as the primary selection with the rotary switch is
displayed on the 7segment LED.
Returns to the secondary selection.
Displays the number selected as the secondary selection when 1 is set as the
primary selection with the rotary switch. When no value is set, the 7segment
LED is off.
Displays the device number set for the display link sharing function when 2 is
selected as the primary selection with the rotary switch.
Memory all clear
D Clears all SRAM data in the memory module. The all clear operation performed after memory module
replacement must be performed by following this method. (The item set when 1 or 2 is selected as the
primary selection with the rotary switch is not cleared by all clear operation using keys on the CRT/MDI.)
When the FROM does not contain the NC system software, this item cannot be executed.
D After completing the primary selection, pressing the pushbutton switch starts allclear processing.
D After processing starts, the indication on the 7segment LED changes as follows:
(Lowspeed blinking) : Allclear processing in progress.
Executed after the pushbutton switch is pressed.
(On) : Normal termination
(Blinking) : SRAM ECC Error
Copies SRAM data into the builtin FROM.
D The SRAM data backed up by battery is copied into the builtin FROM (on the memory module) of the
Power Mate. This is a data backup method performed at printedcircuit board replacement not involving
fuse replacement or memory module mounting/dismounting.
D After completing the primary selection, pressing the pushbutton switch starts processing.
D After processing starts, the indication on the 7segment LED changes as follows:
(Lowspeed blinking) : Save operation in progress.
Executed after the pushbutton switch is pressed.
(On) : Normal termination
(On) : An alarm is issued (such as ROM parity)

Leave a Reply

Your email address will not be published. Required fields are marked *