Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
F. SETTING/DISPLAY/MAINTENANCE
USING THE MAIN UNIT OF
THE Power Mate i
APPENDIX
557
Primary Explanation
Tertiary and
subsequent
operation
Secondary
Saves data to memory (to a memory card) in a batch
D The SRAM data backed up by battery, and the ladder program, C executor user program, and macro
executor user program stored in the FROM are all saved in file form on a memory card in a batch. (The
contents of the system files cannot be saved in a batch.)
D Before data is saved to a memory card, it is formatted. Be careful to avoid having a memory card containing
necessary data formatted.
D The saved data can be restored also using the boot system maintenance operation in the same manner
as explained here.
D After completing the primary selection, pressing the pushbutton switch starts processing.
D After processing starts, the indication on the 7segment LED changes as follows:
(Lowspeed blinking) : Memory card formatting and data saving are in progress.
(Executed after the pushbutton switch is pressed.)
(On) : Normal termination
(On) : An alarm is issued. (Abnormal memory card and so forth)
(On) : An alarm is issued. (Memory card full)
Note) This alarm is issued if the storage capacity of the memory
card in use is smaller than the total size of all the files to be
saved. Use a memory card having a larger storage
capacity.
Restores SRAM data from the builtin FROM.
D SRAM data copied into the builtin FROM by selecting 7 as the primary selection with the rotary switch is
restored in the SRAM.
D After completing the secondary selection, pressing the pushbutton switch starts restoration.
D After restoration starts, the indication on the 7segment LED changes as follows:
(Lowspeed blinking) : Restoration in progress.
Executed after the pushbutton switch is pressed.
(On) : Normal termination
(On) : An alarm is generated.
When saved data is not found.
Restores SRAM data copied into the builtin FROM
Reserved

Leave a Reply

Your email address will not be published. Required fields are marked *