Fanuc Power Mate i-D/H Maintenance Manual

F. SETTING/DISPLAY/MAINTENANCE
USING THE MAIN UNIT OF
THE Power Mate i
B63175EN/03
APPENDIX
560
(1)Do not change the rotary switch position during the above setting
operation; otherwise, the CNC operation becomes unstable.
(2)When the 7segment LED blinks at lowspeed, the frequency is 0.5
Hz. When the LED blinks at highspeed, the frequency is 2 Hz.
(3)When an undefined number is specified with the rotary switch, the
system assumes that 0 has been specified. However, since undefined
numbers are reserved for future function expansion, do not use
undefined numbers.
(4)When data is saved in and restored from a memory card in a batch, the
data is treated as follows:
Table F.4.1 Data in the Power Mate i
Data type Data Size File name
Save/
restoration
allowed/
not allowed
User file
Ladder
program
About 128 to 384
KB
PMCRB.XXX Allowed
C language
executor
About 1.0 MB or
more (varying in
units of 1 MB)
CEX_10M.XXX
to CEX_*0M.XXX
Allowed
FAPT
PICTURE
About 128 KBX CEX0FAPT.XXX Allowed
Macro
About 256 KB PD1M256K.XXX
Allowed
executor
About 512 KB PD1M512K.XXX
SRAM SRAM data
About 256 KB SRAM256A.FDB Allowed
About 512 KB for
each
SRAM1_0A.FDB
SRAM1_0B.FDB
Allowed
* The part XXX is a file extension. As the file extension, one of 32
numbers from 000 to 031 is set.
* The part XXX varies with the size of the C executor. For a file
having a size of 6.0 M, for example, the XXX is named 60M.
When more than one file is stored on the memory card, the file to be
restored has the largest file extension number. (See the example given
below.)
Example: When more than one ladder program file is present:
(1)PMC_RB.000
(2)PMC_RB.001
(3)PMC_RB.002 ³ This file is restored.
(5)Reference position setup flag of the absoluteposition detector
When restoration from a memory card to the system is performed in
a batch, the reference position setup flag (bit 4 of parameter No. 1815)
is cleared. Therefore, after batch restoration, the reference position of
the absoluteposition detector must be set. (Batch restoration is
considered to be performed when the main unit of the Power Mate i
is replaced. In this case, the value in the absoluteposition detector is
lost, so the reference position setup flag is cleared automatically.)
(6)Do not remove or insert the memory card during batch save and
restoration operation.

Leave a Reply

Your email address will not be published. Required fields are marked *