Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
F. SETTING/DISPLAY/MAINTENANCE
USING THE MAIN UNIT OF
THE Power Mate i
APPENDIX
561
In normal operation, the following can be set by using the 7segment LED
and pushbutton switch:
Explanation
D When the pushbutton switch is held down for about five seconds with the rotary switch set to 0, 0 blinks at high speed
on the 7segment LED. Then, when the pushbutton switch is pressed again, primary selection mode explained below
is entered.
D In primary selection mode, numbers corresponding to operations appear one by one.
D When a desired number appears on the 7segment LED, press the pushbutton switch. Then, the LED indication blinks
at high speed. Pressing the pushbutton switch again enters secondary selection mode.
D When the lowest level of each setting has been determined, the finally determined operation value stays indicated on
the LED. (When the pushbutton switch is pressed again, or an alarm is issued in this condition, the ordinary LED
indication state is restored.)
Primary Secondary Explanation
End of this operation
Reserved
Reserved
Uses the following package software:
Cancels the RS232C channel setting made by the secondary selection explained below
(operation 1 to 4).
D To cancel the DPL/MDI operation package (for boot operation) setting made at powerup,
also select this number.
Uses the DPL/MDI operation package for RS232C channel 2.
D This setting is maintained even after power is turned off. When the setting needs to be
cleared, set 0 which is explained above.
D Once this setting is made, boot operation by the DPL/MDI operation package will be enabled
at the next and subsequent powerup operation. (For the operation method, refer to the
operators manual on the DPL/MDI operation package.)
D When 2 is already set in the secondary selection, an error (j) occurs. In such a case, clear
the setting, then set a value again.
Uses FAPT LADDERII for RS232C channel 2.
D This setting is maintained even after power is turned off. When the setting needs to be
cleared, set 0 which is explained above. When 1 is already set in the secondary selection,
an error (j) occurs. In such a case, clear the setting, then set a value again.
Reserved
Reserved
F.4.2
Setting in Normal
Operation

Leave a Reply

Your email address will not be published. Required fields are marked *