Fanuc Power Mate i-D/H Maintenance Manual

G. MAINTENANCE USING A NOTEBOOK
PERSONAL COMPUTER
B63175EN/03
APPENDIX
564
Fig. G.1 (a) shows the hardware and software configurations for using this
function. To use this function, install the following software product
provided by FANUC on the target personal computer in advance:
FANUC Power Mate i
DPL/MDI operation package (specification drawing number: A08B9001J655)
Prepare an RS232C cable which satisfies the specifications shown in
Fig. G.1 (b).
Use the PSW maintenance button and 7segment
LED display to set and operate the RS232C port.
(See G.3.)
Punch panel
For channel 1
A02B0259C191 (1m)
A02B0259C192 (2m)
A02B0259C193 (5m)
For channel 2
A02B0259C051 (1m)
A02B0259C052 (2m)
A02B0259C053 (5m)
The Power Mate i has two RS232C ports,
channel 1 (CH1) and channel 2 (CH2). The
connector on the main unit for connecting
the punch panel is JD42.
CH2.
S IBM PC/AT compatible
S CPU: Pentium (clock: 100 MHz) or better is recommended.
S Memory: 16 MB or more are recommended.
S OS:Windows95/NT
The Power Mate iD/H main unit
S DPL/MDI operation package
(A08B9001J655)
S RS232C cable
(A connection diagram is shown below.)
A02B0259K830
(manufactured by
FANUC)
CH1.
JD42
Fig. G.1 (a) System configuration diagram
D System configuration

Leave a Reply

Your email address will not be published. Required fields are marked *