Fanuc Power Mate i-D/H Maintenance Manual

G. MAINTENANCE USING A NOTEBOOK
PERSONAL COMPUTER
B63175EN/03
APPENDIX
568
8) Terminate the DPL/MDI operation package.
9) Terminate Windows and turn the power to the personal computer
off.
10) Disconnect the RS232C cable from the punch panel on the
Power Mate i.
11) Use the maintenance button and LED display on the Power Mate
i main unit to restore the channel settings to the initial status. (See
additional information 2.)
When the system cannot be started up
When turning the power to the Power Mate i on, perform the following
operations:
1) Confirm that the power to the personal computer is turned
off(NOTE). Then, connect CH2 (see additional information 1
) on
the punch panel on the Power Mate i and RS232C port 1 on the
personal computer (the personal computer port available for the
DPL/MDI operation package is fixed to COM1) using an
RS232C cable.
2) Use the rotary switch for poweron, maintenance button, and
7segment LED display on the Power Mate i to set the channel to
be connected, then turn the power to the Power Mate i off. (See
additional information 3.)
3) Turn the power to the personal computer on to start up Windows.
4) Start the DPL/MDI operation package (for boot operation)
(BOOTINIT.EXE).
5) Turn the power to the Power Mate i on.
6) Perform boot system operation or initialization. (See G.4.)
7) Terminate the DPL/MDI operation package.
8) Terminate Windows and turn the power to the personal computer
off.
9) Disconnect the RS232C cable from the punch panel on the
Power Mate i.
10) Use the rotary switch and LED display on the Power Mate i to
restore the channel settings to the initial status. (See additional
information 2.)
NOTE
When an RS232C cable is connected to the punch panel
on the Power Mate i, voltage from the personal computer
may be present (the power to the personal computer may
be on). In this case, a shortcircuit may occur between the
voltage and 0 V (the shell of the DSUB connector on the
punch panel is 0 V) depending on the connection method,
and hardware of the Power Mate i may be destroyed.
Connect the cable only when the power to the personal
computer is off.

Leave a Reply

Your email address will not be published. Required fields are marked *