Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
G. MAINTENANCE USING A NOTEBOOK
PERSONAL COMPUTER
APPENDIX
571
To perform boot system or initialization (such as memory clear) operation
using the DPL/MDI operation package (for boot operation) when the
system is not started up normally, set the RS232C port using the
procedure below:
(1)Primary selection (selection using the rotary switch)
First, set the MTSW rotary switch to the 1 position before poweron.
(Set the rotary switch before poweron.)
(2)Turn the power to the Power Mate i on.
(3)1 blinks on the 7segment LED display. When the PSW button is
pressed in this status, the LED display enters the secondary selection
mode. The number corresponding to each operation sequentially
appears. (Table G.3 (b))
(4)When 3 is displayed, press the PSW button.
(5)3 blinks. Press the PSW button again. When setting is normally
complete, 3 remains displayed. If setting fails, j (lowercase o)
is displayed. In this case, reference the error condition described in
Table G.3 (b) and perform setting again.
(6)Turn the power to the Power Mate i off, then place the MTSW rotary
switch to the 0 position again.
Table G.3 (b)
Primary
Secondary Tertiary Description
1 Connects a display other than a CRT.
By default, a CRT is selected. Setting this item allows the following
display to be connected.
0 Cancels operation (cancels all selected numbers.)
1 Reserved
2 Connects a handy operators panel. (For BOOT/IPL
operation, another display is required.)
If the CRT/MDI is connected or no handy operators
panel is connected, an error occurs.
3 Uses the DPL/MDI operation package (for boot
operation) on RS232C port 2 (channel 2).
D Make this setting only when the system is not started
up normally and boot or memory clear operation
using the DPL/MDI operation package is required.
When the system is started up normally, to use the
DPL/MDI operation package (for boot operation),
follow the procedure described in additional
information 2 to set the port.
D This setting is retained even after the power is turned
off. To clear the setting, perform operation using the
LED display and button after the system is started
up. (See additional information 2.)
D If 4 is selected for secondary selection and this item
is selected for tertiary or subsequent selection, an
error occurs.
4 Reserved
D Additional information 3
(Setting the RS232C
port (at poweron))

Leave a Reply

Your email address will not be published. Required fields are marked *