Fanuc Power Mate i-D/H Maintenance Manual

G. MAINTENANCE USING A NOTEBOOK
PERSONAL COMPUTER
B63175EN/03
APPENDIX
580
SRAM data reserved after the power to the CNC is turned off (parameters,
programs, etc.) can be saved onto and restored from a memory card at a
time.
When 5.FILE DATA BACKUP/RESTORE is selected, the following
selection screen appears. Pressing ± or ° selects BACKUP or RESTORE.
Pressing ENTER starts saving or restoration.
BACKUP : Saves the SRAM area onto a memory card at a time.
RESTORE : Restores the SRAM area from a memory card at a time.
FILE MENU
4. FILE BACKUP
: Saves file data onto a memory card.
During execution, the following screen appears:
SRAM256A.FDB
BACKUP
: The processing item is displayed and
BACKUP blinks.
When saving or restoration terminates, the selection screen appears again.
To terminate the SRAM DATA BACKUP screen, press the ENTER key
when END is displayed on the screen. The initial screen appears again.
The file name of an SRAM backup on a memory card is
SRAM256A.FDB.
Once this function was used to restore data, be sure to reset a reference
position, if an absolute pulse coder is in use.
G.4.2.5
SRAM DATA BACKUP
screen
D Operation procedure
D Backup file name
D Caution

Leave a Reply

Your email address will not be published. Required fields are marked *