Fanuc Power Mate i-D/H Maintenance Manual

G. MAINTENANCE USING A NOTEBOOK
PERSONAL COMPUTER
B63175EN/03
APPENDIX
582
The boot system is terminated and the Power Mate i is started.
When 10.SYSTEM MONITOR EXIT is selected, the following
confirmation screen appears. Pressing Y starts loading the CNC system
into DRAM and start the INIT operation window. Selecting N displays
the initial screen again.
MONITOR EXIT OK?
HIT [Y] OR [N]
: Confirmation screen
HIT [Y] OR [N] blinks.
During execution of loading, the following screens sequentially appear:
CHECK CNC BASIC
SYSTEM
LOADING BASIC
TO DRAM
CNC BASIC
LOADED
± The INIT operation window starts (Fig. G.4.2.8).
Fig. G.4.2.8
G.4.2.8
LOAD BASIC SYSTEM
D Operation procedure

Leave a Reply

Your email address will not be published. Required fields are marked *