Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
G. MAINTENANCE USING A NOTEBOOK
PERSONAL COMPUTER
APPENDIX
591
3) Method 3
This method is to search for the program number (0001 to 0255)
corresponding to a machine signal and start automatic operation. For
details of operation, refer to the manual supplied by the machine tool
builder.
1 Select the AUTO mode.
2 Select the program screen.
3 Place the system in the reset state.
4 Set the signal for selecting each program number for 01 to 255 on
the machine.
5 Press the cycle start button.
S When the machine signal indicates 00, no program number search
is performed.
S In the reset state, the automatic operation lamp is off.(Refer to the
manual supplied by the machine tool builder.)
(7)Sequence number search
1 Select the AUTO mode.
2 Select the program screen.
3 Select a program with a sequence number to be searched for.
4 Press address N.
5 Key in the sequence number to be searched for.
6 Press cursor key
.
7 When the search is complete, the target sequence number is
displayed.
(8)Deleting a program
1) Deleting one program
1 Select the EDIT mode.
2 Select the program screen.
3 Press address O.
4 Key in a program number.
5 Press
Delete
.The program with the input number is deleted.
2) Deleting all programs
1 Select the EDIT mode.
2 Select the program screen.
3 Press address O.
4 Key in 9999.
5 Press
Delete
.
All programs are deleted.

Leave a Reply

Your email address will not be published. Required fields are marked *