Fanuc Power Mate i-D/H Maintenance Manual

G. MAINTENANCE USING A NOTEBOOK
PERSONAL COMPUTER
B63175EN/03
APPENDIX
592
(9)Operation in the MDI mode
Program number O0000 is automatically inserted. Create a program
to be executed in the same way as when editing an ordinary program.
The created program is not deleted by a reset. To delete the program,
perform operation described in Caution 3.
Check modal information on the diagnosis screen.
CAUTION
1 No operation related to program registration can be
performed.(Program registration, deletion, punch, check,
and other operations)
2 A program consisting of up to six blocks can be created.
However, if a block consists of many characters (using 30
characters as a limit), a program that can be created may
consist of less than six blocks.
3 To delete all of the created program,
press and .
Bit 7 of parameter No. 3207 can be set to 1 to delete all
programs by a reset.
O
Delete
(10)Background editing
1 Press
F2
PRG
and
Back
Space
simultaneously to place the system in the
background editing state.
2 Specify a program to be edited.
a) To create a program
1) Press address O.
2) Key in a program number.
3) Press
Insert
. The program is specified and displayed.
b) To edit an existing program
1) Press address O.
2) Key in a program number.
3) Press
. The program is searched for and displayed.
3 Editing a program
Edit a program in the same way as when editing a program in the
foreground.
4 Terminating background editing
Press
F2
PRG
and
Back
Space
simultaneously to terminate background
editing.

Leave a Reply

Your email address will not be published. Required fields are marked *