Fanuc Power Mate i-D/H Maintenance Manual

G. MAINTENANCE USING A NOTEBOOK
PERSONAL COMPUTER
B63175EN/03
APPENDIX
596
Press
F3
MEN
VAR
. The offset screen, setting screen, and custom macro variable
screen alternately appear. Select the setting screen.
1 Move the cursor to the position of a setting to be changed.
2 Key in 1 or 0 by referencing the following explanation.
3 Press
Enter
. The data is input and displayed.
Description of settings
1 Parameter writing (PWE)Specifies whether to enable a parameter
to be written.
0 : Disables a parameter to be written.
1 : Enables a parameter to be written.
2 TV check (TVON)
Specifies whether to perform a TV check.
0 : Does not perform a TV check.
1 : Performs a TV check.
3 Punch code (ISO)
Sets the code to be used for outputting data from the reader/punch
interface.
0 : Outputs the EIA code.
1 : Outputs the ISO code.
4 Input unit (INCH)
Sets the input unit: inch or millimeter.
0 : Millimeter
1 : Inch
G.5.2.3
Settings
D Display operation

Leave a Reply

Your email address will not be published. Required fields are marked *