Fanuc Power Mate i-D/H Maintenance Manual

G. MAINTENANCE USING A NOTEBOOK
PERSONAL COMPUTER
B63175EN/03
APPENDIX
598
1 Move the cursor to the position of the number of an offset value to
be changed as follows:
1) Cursor key
2) Press
F6
&@
No.
. H is displayed following >.
>H
Then, enter an offset number.
Press
Enter
. The cursor moves to the target number position.
When this method is used, the cursor is always displayed on the
first line.
2 Key in a new offset value, then press
Enter
. The new offset
value is input and displayed.
(1)Offset (input)
1 Select the EDIT mode.
2 Select the offset screen.
Press
F3
MEN
VAR
. The offset screen, setting screen, and custom macro
variable screen alternately appear. Select the offset screen.
3 When offset values are stored in a file in a device, perform file
heading as required.
4 Press
F7
RD
to input the offset values.
During input, RD is displayed as follows:
> RD
(2)Offset (output)
1 Select the EDIT mode.
2 Select the offset screen.
Press
F3
MEN
VAR
. The offset screen, setting screen, and custom macro
variable screen alternately appear. Select the offset screen.
3 Press
F8
WRT
to output the offset values.
During output, WRT is displayed as follows:
> WRT
D Rewriting procedure

Leave a Reply

Your email address will not be published. Required fields are marked *