Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
G. MAINTENANCE USING A NOTEBOOK
PERSONAL COMPUTER
APPENDIX
601
Press
F4
DGN
PRM
. The parameter screen, diagnosis screen, and pitch
error compensation screen alternately appear. Select the parameter
screen.
1 Set PWE to 1 on the setting screen.
2 Move the cursor to the position of the number of a parameter to be
changed as follows:
1) Cursor key
2) Press
F6
&@
No.
. & is displayed following >.
>&
Then, enter a parameter number.
Press
Enter
. The cursor moves to the target number position.
When this method is used, the cursor is always displayed on the
first line.
3 Key in a new value, then press
Enter
. The new parameter value is
input and displayed.
4 After setting and checking all parameters, display the setting screen
and set PWE to 0.
5 Press
Back
Space
to release the alarm state.
If alarm number 000 occurs, however, the alarm can be released
only by turning the power off, then on again.
G.5.2.6
Parameter
D Display operation
D Rewriting procedure

Leave a Reply

Your email address will not be published. Required fields are marked *