Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
G. MAINTENANCE USING A NOTEBOOK
PERSONAL COMPUTER
APPENDIX
609
Files can be manipulated by selecting File from the main menu, then
each item from the pulldown menu.
A file in the personal computer can be opened and the contents can be
referenced.
The following data files in the Power Mate i can be backed up onto the
hard disk in the personal computer:
D CNC PARAMETER (CNC parameter)
D PITCH ERROR COMPENSATION (Pitch error compensation)
D TOOL OFFSET (Tool offset value)
D MACRO VARIABLE (macro variable)
D CNC PROGRAM (CNC program)
The ISO code is used for data transferred during use of this function
regardless of which value is set for bit 1 of parameter No. 0.
Put the CNC in the EDIT or emergency stop mode.
G.5.3
File Transfer and
Printing Function
G.5.3.1
Referencing a file
G.5.3.2
Backing up a CNC data
file
D Transfer data code
D Mode during transfer

Leave a Reply

Your email address will not be published. Required fields are marked *