Fanuc Power Mate i-D/H Maintenance Manual

G. MAINTENANCE USING A NOTEBOOK
PERSONAL COMPUTER
B63175EN/03
APPENDIX
610
The output formats are shown below.
(NC program format)
%(program1) (program2) (programN) %
Feed by 1 foot Feed by 1 foot
D Bit 3 (NCR) of parameter No. 0100 can be used to specify
whether to punch two CRs following LF or punch only LF.
(Tool offset format)
%
G10L11P_R_;
P_: Offset number
R_: Tool offset value
%
(Macro variable format)
%
;
#500=[25283*65536+65536]/134217728 (1)
#501=#0; (2)
#502=0; (3)
;
#699 ;
M02;
%
1 The value of a variable is output as an expression to maintain the
accuracy of the variable.
2 Undefined variable
3 When the value of a variable is 0
(Pitch error compensation format)
%
N10000P...;
N11023P..........;
%
N...: Pitch error compensation point number + 10000
P...: Pitch error compensation data
D Output format

Leave a Reply

Your email address will not be published. Required fields are marked *