Fanuc Power Mate i-D/H Maintenance Manual

H. FSSB STARTUP PROCEDURE/
MATERIALS
B63175EN/03
APPENDIX
620
In a system using the FSSB, the CNC, servo amplifiers, and pulse
modules are connected with each other via optical cables. These
amplifiers and pulse modules are referred to as slaves. Assume that a
2axis amplifier consists of two slaves, and a 3axis amplifier consists
of three slaves. Slave numbers (1, 2, 3, ..., 10) are assigned to the slaves
in ascending order; a younger number is assigned to a slave that is closer
to the CNC.
Slave
No.
Control
axis
No.
Program
axis name
No. 1020
1 axis AMP
Laxis
2 axis AMP
Maxis
Laxis
2 axis AMP
Maxis
M1
1 axis AMP
M2
Note) M1/M2: Pluse Module 1st/2nd
H.2
SLAVE

Leave a Reply

Your email address will not be published. Required fields are marked *