Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
H. FSSB STARTUP PROCEDURE/
MATERIALS
APPENDIX
621
When the following parameters are set, automatic setting can be
performed using the FSSB setting screen:
Bit 0 of No. 1902 = 0
Bit 1 of No. 1902 = 0
For automatic setting on the FSSB setting screen, use the procedure
below.
1 Set a servo axis number in No. 1023.
Be sure to match an axis number set in No. 1023 with the total number
of axes of the servo amplifiers connected via optical cables.
2 On the servo initialization screen, initialize the servo parameters.
3 Turn off then on the power to the CNC.
4 Press function key
SYSTEM
.
5 Pressing the continuous menu key
several times displays
[FSSB].
6 Pressing soft key [FSSB] switches the screen display to the amplifier
setting screen (or the FSSB setting screen selected previously), and
displays the following soft keys:
[ ][ ][ ][ ][ ]
7 Press soft key [AMP].
8 On the amplifier setting screen, set a controlled axis number connected
to each amplifier.
The amplifier setting screen lists the slaves in ascending order of slave
numbers from top to bottom. So, when setting controlled axis
numbers, consider which amplifier axis is to be connected to which
CNC axis, sequentially, starting with the amplifier axis closest to the
NC. On this setting screen, 0 and duplicate numbers cannot be entered.
No. AMP SERIES UNIT CUR. [AXIS] NAME
1A1L α SVM 40AL [ 1 ] X
2A1M α SVM 12A [ 2 ] Y
3A2L β SVU 20A [ 3 ] Z
4A3L α SVM 40A [ 4 ] A
5A3M α SVM 80A [ 5 ] B
7A4L α SVM 40AS [ 6 ] C
NO. EXTRA PCB ID
6 M1 A 0008 DETECTOR(4AXES)
8 M2 A 0008 DETECTOR(4AXES)
>
MDI **** *** *** 13:11:56
[ AMP ][ AXIS ][ MAINT ][ ][ (OPRT) ]
9 Press soft key [SETING]. (This soft key appears when a value is
entered.)
10 Press function key
SYSTEM
.
H.3
AUTOMATIC
SETTING

Leave a Reply

Your email address will not be published. Required fields are marked *