Fanuc Power Mate i-D/H Maintenance Manual

H. FSSB STARTUP PROCEDURE/
MATERIALS
B63175EN/03
APPENDIX
622
11 Pressing the continuous menu key several times displays
[FSSB].
12 Pressing soft key [FSSB] switches the screen display to the amplifier
setting screen, and displays the following soft keys:
[ AMP ][ AXIS ][ MAINT ][ ][ (OPRT) ]
13 Press soft key [AXIS].
14 On the axis setting screen, set information on each axis.
15 The axis setting screen lists the CNC axes in ascending order of axis
numbers from top to bottom.
When any of the following is to be performed for each axis, the setting
of this screen is required:
S Use of a separate detector
S Exclusive use of a DSP (CPU for servo control) by one axis (for use
of a current loop period of 125 µs, for example)
S Use of tandem control
(AXIS SETTING)
AXIS NAME AMP M1 M2 IDSP Cs TNDM
1XA1L1 0 0 0 0
2YA1M0 1 0 0 0
3ZA2L0 0 0 0 0
4AA3L2 0 0 0 0
5BA3M0 2 0 0 0
6CA4L0 0 0 0 0
>
MDI **** *** *** 13:11:56
[ AMP ][ AXIS ][ MAINT ][ ][ (OPRT) ]
16 Press soft key [SETING]. (This soft key appears when a value is
entered.)
This operation starts an automatic calculation, and parameter Nos. 1023,
1905, 1910 through 1919, 1936, and 1937 are automatically set.
Bit 1 of parameter No. 1902 is set to 1 to indicate that each of these
parameters has been set. When the power is turned off then back on, axis
settings are made according to each parameter.
[ Using the twopath control function of the Power Mate iD disables
the automatic setting. In this case, use manual setting 1 or 2.

Leave a Reply

Your email address will not be published. Required fields are marked *