Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
H. FSSB STARTUP PROCEDURE/
MATERIALS
APPENDIX
623
Zaxis
Aaxis
Xaxis
Yaxis
Step 1 Set the following with parameter No. 1023:
X : 1
Y : 2
Z : 3
A : 4
Step 2 Initialize the servo parameters for each axis.
Step 3 Turn on then off the power to the CNC.
Step 4 Enter the axis numbers on the amplifier setting screen.
(AMPLIFIER SETTING)
No. AMP SERIES UNIT CUR. [AXIS] NAME
1A1L α SVM 40A [ 2 ] Y
2A2L α SVM 40A [ 1 ] X
3A3L α SVM 40A [ 4 ] A
4A3M α SVM 80A [ 3 ] Z
NO. EXTRA TYPE PCB ID
>
MDI **** *** *** 13:11:56
[ AMP ][ AXIS ][ MAINT ][ ][ (OPRT) ]
Step 5 Press soft key [SETING]. (This soft key appears when a value
is entered.)
Step 6 Press function key
SYSTEM
.
H.3.1
[Sample Setting 1]
General Configuration
(SemiClosed Loop)

Leave a Reply

Your email address will not be published. Required fields are marked *