Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
H. FSSB STARTUP PROCEDURE/
MATERIALS
APPENDIX
627
Step 4 Enter the axis numbers on the amplifier setting screen.
(AMPLIFIER SETTING)
No. AMP SERIES UNIT CUR. [AXIS] NAME
1A1L α SVM 40A [ 2 ] Y
2A2L α SVM 40A [ 1 ] X
3A3L α SVM 40A [ 4 ] A
4A3M α SVM 80A [ 3 ] Z
5A4L α SVM 40A [ 5 ] B
NO. EXTRA TYPE PCB ID
>
MDI **** *** *** 13:11:56
[ AMP ][ AXIS ][ MAINT ][ ][ (OPRT) ]
Step 5 Press soft key [SETING]. (This soft key appears when a value
is entered.)
Step 6 Press function key
SYSTEM
.
Step 7 Pressing the continuous menu key
several times displays
[FSSB].
Step 8 Pressing soft key [FSSB] switches the screen display to the
amplifier setting screen, and displays the following soft keys:
[ AMP ][ AXIS ][ MAINT ][ ][ (OPRT) ]
Step 9 Press soft key [AXIS].
Step 10 Set the tandem axes on the axis setting screen. (TNDM)
(AXIS SETTING)
AXIS NAME AMP M1 M2 1DSP Cs TNDM
1XA2L0 0 0 0 1
2YA1L0 0 0 0 3
3ZA3M0 0 0 0 0
4AA3L0 0 0 0 2
5BA4L0 0 0 0 4
>
MDI **** *** *** 13:11:56
[ AMP ][ AXIS ][ MAINT ][ ][ (OPRT) ]
Step 11 Press soft key [SETING]. (This soft key appears when a value
is entered.)
Step 12 Turn off then on the power to the CNC. This completes the
setting.

Leave a Reply

Your email address will not be published. Required fields are marked *