Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
H. FSSB STARTUP PROCEDURE/
MATERIALS
APPENDIX
629
Con-
trolled
axis No.
Program
axis name
No.1020
Servo
axis No.
No.1023
Interface
type
Fast/Slow
2axis AMP
1axis AMP
2axis AMP
1axis AMP
#6 (PM1) The first pulse module is:
0 : Not used.
1 : Used.
#7 (PM2) The second pulse module is:
0 : Not used.
1 : Used.
This parameter is automatically set by data input on the FSSB setting
screen when the FSSB setting mode is the automatic setting mode (when
bit 0 of parameter No. 1902 = 0). When the manual setting 2 mode is used
(when bit 0 of parameter No. 1902 = 1), be sure to enter necessary data
directly.
When a pulse module is used, connector numbers (parameter Nos. 1936
and 1937) need to be set.
1910 Address conversion table value for slave 1 (ATR)
PRM
1911 Address conversion table value for slave 2 (ATR)
PRM
1912 Address conversion table value for slave 3 (ATR)
PRM
1913 Address conversion table value for slave 4 (ATR)
PRM
1914 Address conversion table value for slave 5 (ATR)
PRM
1915 Address conversion table value for slave 6 (ATR)
PRM
1916 Address conversion table value for slave 7 (ATR)
PRM
1917 Address conversion table value for slave 8 (ATR)
PRM
1918 Address conversion table value for slave 9 (ATR)
PRM
1919 Address conversion table value for slave 10 (ATR)
PRM
[Data type] Byte
[Valid data range] 0 to 7, 16, 40, 48
Set an address conversion table value for each of slave 1 through 10.

Leave a Reply

Your email address will not be published. Required fields are marked *