Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
I. MAINTENANCE WITH DISPLAY
LINK TYPED TOUCH PANEL
APPENDIX
649
D Your application software can be installed from PC to CNC via a
memory card. At first, the application software is stored in the memory
card in MEMformat (memory card format). Then register the data
from the memory card into the FROM in the CNC. Please refer to the
chapter 3.1 Boot System Operation Method in this document about
the detail operation.
(CNC initializing operation)
D Please refer to the chapter 3.2 CNC initializing operation if
initializing operation, such as memory clear, is required.
(CNC/PMC maintenance operation in normal condition)
D You can make the switching button, that switches the control of the
screen from the application screen to the CNC maintenance screen, on
the application screen of each CNC. By this button, you can select the
CNC maintenance screen (setting CNC data, etc.) and PMC
maintenance screen (ladder editing, etc.). If the CNC maintenance
operation, such as setting parameters or other CNC data, is required,
please switch the screen and perform the maintenance operation.

Leave a Reply

Your email address will not be published. Required fields are marked *