Fanuc Power Mate i-D/H Maintenance Manual

I. MAINTENANCE WITH DISPLAY
LINK TYPED TOUCH PANEL
B63175EN/03
APPENDIX
650
(1)In case that a device select switch is connected with the display unit,
select the CNC to be maintained by selecting the device number.
(2)Turn on the power of the display unit with touching the upper left part
on the touch screen. In a little while, the maintenance operation
screen shown in Fig I.2(a) is displayed. If the power of CNC is not
turned on, the maintenance operation screen shown in Fig I.2(b) is
displayed.
Touch screen
Turn on power
with touching
this part
S E L E C T T H E M A I N T E N A N C E O P E R A T I O N
+ +
+ +
+ +
+ +
+ +
+ +
+ +
+ +
+ +
BOOT SYSTEM
TOUCH PANEL SCREEN SETT I NG
CANCEL
Fig. I.2(a) The main menu screen of maintenance operation
NOTE
Touching on a touch screen
A touch screen has the characteristic that the response is
not good if touching area is rather wide. Please touch with
the pen for touch screen or the like.
I.2
MAINTENANCE
OPERATION OF
DISPLAY UNIT WITH
TOUCH PANEL

Leave a Reply

Your email address will not be published. Required fields are marked *