Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
I. MAINTENANCE WITH DISPLAY
LINK TYPED TOUCH PANEL
APPENDIX
653
(1)Touch at nine points just on the mark + respectively with the pen for
touch screen. If touching is recognized, the mark is changed to F.
After all nine points are touched, touch on INPUT. Then the
adjustment data is memorized in FROM and the following message
is displayed..
CALIBRATION HAS BEEN NORMAL FINISHED.
SAVING THE CALIBRATION DATA.
>NORMAL END
It is possible to cancel this adjustment before finishing. You can
perform this adjustment from the beginning by touching CANCEL.
(2)When EXIT is touched, the main menu of touch screen setting,.Fig
23, is displayed.
NOTE
Usually, it is not necessary to adjust touching point because
this adjustment is done when shipping. When a display unit
is changed or touch position gets out of position, adjust
touch position by above procedure.
When selecting OTHERS on the menu screen shown in the Fig.I.2(c),
the following menu screen is displayed.
\ O T H E R S \
+ +
[ ]
+ +
[ ]
+ +
[ ]
+ +
[ ]
+ +
[ ]
+ +
[ ]
+ +
[ ] [ ]
D I AGNOS I S
INFORMATION
CONTROL
SOFTWARE
MA I N T E N ANC E
OTHERS SETTING
EXIT CANCEL
Fig. I.2.3 Other maintenance operation screen
DIAGNOSIS INFORMATION: Display the series and edition of the
control software of the display unit
CONTROL SOFTWARE MAINTENANCE: Saving/loading the
control software of the
display unit
OTHERS SETTING: Setting the kind of a separate type MDI
I.2.3
Other Setting
Operation

Leave a Reply

Your email address will not be published. Required fields are marked *