Fanuc Power Mate i-D/H Maintenance Manual

I. MAINTENANCE WITH DISPLAY
LINK TYPED TOUCH PANEL
B63175EN/03
APPENDIX
654
When selecting DIAGNOSIS INFORMATION on the menu screen
shown in the Fig.I.2.3, the following information is displayed.
\ D I A G N O S I S I N F O R M A T I O N \
+ +
[ ]
CONTROL SOF TWARE SER I E S / EDT I ON
[ S YSTEM (D I SPLAY S I DE ) : [ 8 8 1K / 0 0 1A ]
[ VGA (D I SPLAY S I DE ) : [ 6 0V2 / 0 0 1B ]
Series/edition of control
software of display unit
Series/edition of control
software of VGA
EXIT
Fig. I.2.3.1 Diagnosis information screen
When selecting CONTROL SOFTWARE MAINTENANCE on the
menu screen shown in the Fig.I.2.3, the following maintenance screen of
control software is displayed.
NOTE
This operation is not needed usually. This operation should
be done, only when versionup of the control software is
required because of the enhancement of functions.
\ C O N T R O L S O F T W A R E M A I N T E N A N C E \
+ +
[ ]
+ +
[ ]
+ +
[ ]
+ +
[ ]
+ +
[ ]
+ +
[ ]
+ +
[ ]EXI T
MA I N ME N U
1 . CONTROL SOFTWARE SAVI NG
2 . CONTROL SOFTWARE LOADI NG
Fig. I.2.3.2 Maintenance operation screen of the control software of
display unit
CONTROL SOFTWARE SAVING: Save the control software of
display unit into a memory card
I.2.3.1
Diagnosis information
screen
I.2.3.2
Maintenance of control
software

Leave a Reply

Your email address will not be published. Required fields are marked *