Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
I. MAINTENANCE WITH DISPLAY
LINK TYPED TOUCH PANEL
APPENDIX
655
CONTROL SOFTWARE LOADING: Load the control software of
display unit from a memory
card
When you select OTHERS SETTING Fig.I.2.3, the following screen
is displayed.
\ O T H E R S S E T T I N G \
+ +
[ ]
+ +
[ ]
+ +
[ ]
+ +
[ ]
+ +
[ ]
+ +
[ ]
+ +
[ ] [ ]
EXIT
SE PARATED MD I KEY BOARD TYPE
NOT USED ] [MD I T1 ]
CANCEL
SEPARATED MDI KEY BOARD TYPE
[NOT USED]: Separate type MDI keyboard is not connected.
[MDIT1]: Separate type MDI keyboard (A02B0236C120)
is connected.
EXIT This operation is finished after setting value is memorized.
CANCEL This operation is finished without memorizing
NOTE
In case that [NOT USED] is selected (the separate type MDI
keyboard is not used), the virtual MDI keyboard is displayed
on the CNC/PMC screen when CNC maintenance screen
or PMC maintenance screen is selected. The setting or
display on the CNC operation is performed by touching this
virtual MDI keyboard.
I.2.3.3
Other setting

Leave a Reply

Your email address will not be published. Required fields are marked *