Fanuc Power Mate i-D/H Maintenance Manual

I. MAINTENANCE WITH DISPLAY
LINK TYPED TOUCH PANEL
B63175EN/03
APPENDIX
660
Selected character
Initializing operation
KEY 1 KEY 2
Clear all memory 7
or
<RST>
9
<DEL>
Clear all memory [1st path side of 2 path control] <CAN> 1
Clear all memory [2nd path side of 2 path control] <CAN> 2
Clear parameters and offset data <RST>
Clear parameter and offset data [1st path side of
2 path control]
<RST> 1
Clear parameter and offset data [2nd path side of
2 path control]
<RST> 2
Clear part program <DEL>
Clear part program [1st path side of 2 path control] <DEL> 1
Clear part program [2nd path side of 2 path
control]
<DEL> 2
Clear ladder program X O
Clear PMC parameter Z O
Reset OT alarm <CAN> P
Select 1 path system (Only in Power Mate iD) 1 S
Select 2 path system (Only in Power Mate iD) 2 S
Note) Do not care the order of selection KEY 1 and KEY 2. Even if
the order is reversed, the result is the same.
Also, the initializing operation without designating KEY 2 can
be executed by selecting only KEY 1.
NOTE
1 Once 1 or 2 path system is selected by above operation in
Power Mate iD, it is not necessary to execute above
selection at every poweron.
2 If the selection about 1 or 2 path system is changed in Power
Mate iD, the value of the parameter is initialized to the
default value and other data, such as offset data, macro
variable and so on, is cleared to zero.
I.3.2.2
List of initializing
operation

Leave a Reply

Your email address will not be published. Required fields are marked *