Fanuc Power Mate i-D/H Maintenance Manual

I. MAINTENANCE WITH DISPLAY
LINK TYPED TOUCH PANEL
B63175EN/03
APPENDIX
662
This SPCL key is used in the operation that two keys are pushed at the
same time.
1) Select the special key input mode by touching SPCL key. Then the
color of the key turns blue.
2) Touch two keys, that you want to push at the same time, one after
another.
If three or more keys are touched, last two keys are effective.
3) The operation of two keys is executed by touching ENTER key.
SPCL (special) key input mode is cancelled by touching ENTER key
or SPCL key.
But if SPCL mode is cancelled by touching SPCL key, the key input
information during SPCL mode is invalid.
When the fine display mode in PMC maintenance screen, such as ladder
monitoring screen, is selected, the virtual MDI keyboard (Function menu)
shown in Fig.I.4.2.1 is displayed. You can switch the screen to CNC
maintenance operation screen by touching each function key.
[ ] [ ]
[ ] [ ] [ ]
MENU
KEY
ON
POS
PRG
OFS
SYS
MSG
CUS
LADDER * *NET 00010005 MONIT RUN
1
SPACE
SUB24
TMRB
SUB 1
END1
R0020.0 R0021.1
R0020.2 R0020.1
R0020.5
R0022.1
R0
ACT
R0022.
1
Fig. I.4.2.1 Virtual MDI keyboard on PMC maintenance screen (Function menu)
I.4.1.1
Operation of SPCL key
I.4.2
PMC Maintenance
Screen
I.4.2.1
Virtual MDI keyboard in
PMC maintenance
screen (function menu)

Leave a Reply

Your email address will not be published. Required fields are marked *