Fanuc Power Mate i-D/H Maintenance Manual

I. MAINTENANCE WITH DISPLAY
LINK TYPED TOUCH PANEL
B63175EN/03
APPENDIX
670
NOTE
1 In case that the value 4 is set to the parameter No.20,
reading/punching is performed through the memory card
slot on the cabinet of the Power Mate.
2 When the parameter No.20 is set the value 7, memory
card input/output screen on ALL IO screen is not available
even if the parameter No.3116#0 (MDP) is set to 1.
Usually the memory card input/output screen is displayed
when the softkey [MCARD] on ALL IO screen is pushed.
But, when the value 7 is set to the parameter No.20, the
softkey [MCARD] is not displayed.
4. Operations on memory card directory display
This screen is displayed by pushing the softkey [CARD] on the
program screen in EDIT mode.
NOTE
In the following functions, it is impossible to read/punch data
through the memory card slot on the touch panel.
1 Boot system function
(Therefore, it is impossible to input/output data which can
be handled only on the boot system, like system
software, picture data made by Fapt Picture,
Clanguage executor, macro executor, and so on.)
2 External I/O device control
3 Memory card access function by C Language executor
application program

Leave a Reply

Your email address will not be published. Required fields are marked *