I. MAINTENANCE WITH DISPLAY
LINK TYPED TOUCH PANEL
The error code of the file system is shown in the following table.
Table I.6.2.3(b) Error code of file system
102 Vacancy of a memory card is not enough.
105 A memory card is not mounted.
106 A memory card has already been mounted.
110 The specified directory is not found.
111 In the root directory, the numbers of files are too many to add a
114 The specified file name is not found.
115 The specified file is protected.
117 The file is not opened.
118 The file has already been opened.
119 The file is locked.
122 The specified file name is not correct.
124 The extender of the specified file name is not correct.
129 Not supported function is specified.
130 The device is specified incorrectly.
131 The specified pass name is not correct.
133 Two or more files are opened at a time.
135 The device is not formatted.
140 The attribute of the file is ”unable to read/write”.
D The information saved into a memory card is compatible only with the
CNC with the same hardware configuration and the same option
D SRAM memory card and Flash ATA card are available. It is impossible
to use a flash memory card.