Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
I. MAINTENANCE WITH DISPLAY
LINK TYPED TOUCH PANEL
APPENDIX
675
#7
DMDIU3191
#6 #5 #4 #3 #2 #1 #0
[Data type] Bit
DMDIU Full screen display selecting softkey is
0 : not displayed.
1 : displayed.
NOTE
If the value of this parameter is changed, the value is valid
after next poweron.
#7
8650
#6 #5 #4 #3 #2 #1
CNA
#0
RSK
[Data type] Bit
RSK When RESET key is pushed, key code is
0 : not transferred to the application software.
1 : transferred to the application software.
CAN When NC alarm occurs while the screen by FAPT PICTURE (Windows)
or the user screen by Clanguage executor is displayed,
0 : whether the screen is changed to the CNC alarm screen or not is
depends on the setting of the parameter No.3111#7 (NPA).
1 : the screen is not changed to the CNC alarm screen.
NOTE
If the value of this parameter is changed, the value is valid
after next poweron.
8781 DRAM size used by FAPT PICTURE or Clanguage executor
[Data type] Byte
[Unit of data] 64Kbyte
[Valid data range] 1696
The DRAM size for FAPT PICTURE (Windows) or Clanguage executor
is set.
When FAPT PICTURE (Windows) is used on Power Mate iD/H, this
value should be fixed to 96.
NOTE
If the value of this parameter is changed, the value is valid
after next poweron
Actual DRAM size is also restricted by the capacity of DRAM
and the option assembly.

Leave a Reply

Your email address will not be published. Required fields are marked *