Fanuc Power Mate i-D/H Maintenance Manual

FANUC Power Mate i - MODEL D/H
The parameter set supporting screen
function
TITLE
PARAMETER TUNING O1234N12345
NENU
1.START UP
AXIS SETTING
FSSB(AMP)
FSSB(AXIS)
SERVO SETTING
MISCELLANY
2.TUNING
SERVO TUNING
SPINDLE TUNING (only PMi-D)
MDI ***** *** ***
[PARAM] [DGNOS] [ PMC ] [SYSTEM] [(OPRT)]
Figure 1.4.3 (a) Menu screen of parameter set supporting screen
General of each item
The generals of each item displayed in parameter set supporting screen
are as follows.
[1.START UP]
In the item of “START UP”, the parameter necessary for machine start-up
can be set.
AXIS SETTING : Set parameters for axis, coordinate,
feedrate and acceleration /deceleration
FSSB (AMP) : Display the FSSB amp setting screen. (Note1)
FSSB (AXIS) : Display the FSSB axis setting screen. (Note1)
SERVO SETTING : Display the Servo setting screen.
MISCELLANY : Set the parameter for DI/DO, Serial Spindle.
[2.TUNING]
In the item of TUNING, the screen of adjust Servo or Spindle is
displayed.
SERVO TUNING : Display the Servo tuning screen.
SPINDLE TUNING : Display the Spindle tuning screen.
(only PMi-D)
Note 1. This screen can not be displayed in the two path system of PMi-D.
EDIT
DATE DISIGNE
DESCRIPTION
DRAW
B-63175EN/03-8
SHEET
3/11
APPROV.
FANUC LTD
New design 030207
01

Leave a Reply

Your email address will not be published. Required fields are marked *