Fanuc Power Mate i-D/H Maintenance Manual

FANUC Power Mate i - MODEL D/H
The parameter set supporting screen
function
TITLE
Selection of the item
Press the [(OPRT)] soft key and display the following soft key.
[SELECT][ ][ ][ ][ ]
Press the key to position the cursor to desired item
Press the [SELECT] soft key.
1.4.3 [1. START UP]
Display of screen
In the item of [1. START UP], the parameter necessary for machine
start-up can be set. In this section, the item of “AXIS SETTING”
and ”MISCELLANY” are explained.
For the detail of “FSSB(AMP)”, “FSSB(AXIS)” and “SERVO SETTING”,
refer to the item of digital servo in this manual.
This function selects, classifies to the group and displays the parameter
necessary for machine start-up. Explanation of the each group is as
follows.
Items of ”AXIS SETTING”
(BASIC) group : Display the parameter for basic setting.
(COORDINATE) group : Display the parameter for coordinate
(FEED RATE) group : Display the parameter for feed rate.
(ACC./DEC.) group : Display the parameter for ACC./DEC.
Item of “MISCELLANY”
(MISC) group : Display the parameter for DI/DO, setting of
the Serial Spindle or so on.
The simple help message for the parameter pointed by cursor will be
displayed. And if the standard value for parameter (FANUC
recommendation) is exist, its value will be displayed.
EDIT
DATE DISIGNE
DESCRIPTION
DRAW
B-63175EN/03-8
SHEET
4/11
APPROV.
FANUC LTD
New design 030207
01

Leave a Reply

Your email address will not be published. Required fields are marked *