Fanuc Power Mate i-D/H Maintenance Manual

Ed
Pa
g
e
7 / 14
Date
Si
g
n
Co
n
te
n
ts
Power Mate
i
-MODEL D/H
Corresponding to
α
i series servo
B-63175EN/03-13
07/11/30
01
N
ewly make out
TITLE
DRAWING
Signal
Servo warning detail signal
SVWRN1 to SVWRN4
F93#4 TO F93#7
[Classification] Output signal
[Function] The corresponding warning signal is notified by the state of the servo amplifier.
[Condition] It is shown the corresponding warning signal and the warning state of the servo
amplifier in the following.
Servo warning detail signal (F93)
Corresponding alarm message
SVWRN4
(#7)
SVWRN3
(#6)
SVWRN2
(#5)
SVWRN1
(#4)
Time to becoming alarm after
warning state signal is generated
444 n axis: INV. COOLING FAN FAILURE 1 0 0 0 one minute
601 n axis:INV. RADIATOR FAN FAILURE 1 0 0 1 until becoming overheat(irregularity)
443 n axis:CNV. COOLING FAN FAILURE 1 1 0 0 one minute
606 n axis:CNV. RADIATOR FAN FAILURE 1 1 0 1 until becoming overheat(irregularity)
431 n axis:CNV. OVERLOAD 1 1 1 0 one minute
607 n axis:CNV. SINGLE PHASE FAILURE 1 1 1 1 PSMR:five seconds,PSM:one minute
Signal address
#7 #6 #5 #4 #3 #2 #1 #0
F093 SVWRN4 SVWRN3 SVWRN2 SVWRN1
FAN alert message
The alert message of 'FAN' is displayed on the screen at following Warning
before the alarm occurs.
This alert message is displayed only when the parameter No.1807#2 is 1.
[Warning for FAN]
Content of warning
INV. COOLING FAN FAILURE
INV. RADIATOR FAN FAILURE
CNV. COOLING FAN FAILURE
CNV. RADIATOR FAN FAILURE

Leave a Reply

Your email address will not be published. Required fields are marked *