Fanuc Power Mate i-D/H Maintenance Manual

SAFETY PRECAUTIONS
B63175EN/03
s6
5
WARNINGS RELATED TO DAILY MAINTENANCE
WARNING
1. Memory backup battery replacement
When replacing the memory backup batteries, keep the power to the machine (CNC) turned on,
and apply an emergency stop to the machine. Because this work is performed with the power
on and the cabinet open, only those personnel who have received approved safety and
maintenance training may perform this work.
When replacing the batteries, be careful not to touch the highvoltage circuits (marked
and
fitted with an insulating cover).
Touching the uncovered highvoltage circuits presents an extremely dangerous electric shock
hazard.
NOTE
The Power Mate uses batteries to preserve the contents of its memory, because it must retain data
such as programs, offsets, and parameters even while external power is not applied.
If the battery voltage drops, a low battery voltage alarm is displayed on the machine operators panel,
CRT screen, or etc..
When a low battery voltage alarm is displayed, replace the batteries within a week. Otherwise, the
contents of the Power Mates memory will be lost.
To replace the battery, see the procedure described in Section 2.8 of this manual.

Leave a Reply

Your email address will not be published. Required fields are marked *