Fanuc Power Mate i-D/H Maintenance Manual

1. DISPLAY AND OPERATION
B63175EN/03
62
0410 Load meter of spindle [%]
DGN
0411 Speed meter of spindle [%]
DGN
0417 Feedback information of spindle position coder
DGN
0418 Position error of spindle position loop mode
DGN
450 Spindle position error during rigid tapping
DGN
[Data type] Word
[Unit of data] Detection units
451 Spindle distribution during rigid tapping
DGN
[Data type] Word
[Unit of data] Detection units
454 Accumulated spindle distribution during rigid tapping
DGN
[Data type] Twoword
[Unit of data] Detection units
455 Instantaneous difference for the move command, calculated in terms of the spindle,
during rigid tapping (signed, accumulated value)
DGN
[Data type] Twoword
[Unit of data] Detection units
456 Instantaneous difference for the travel error, calculated in terms of the spindle,
during rigid tapping (signed)
DGN
[Data type] Word
[Unit of data] Detection units
457 Width of synchronization error during rigid tapping (maximum value)
DGN
[Data type] Word
[Unit of data] Detection units
D Diagnostic data related
to rigid tapping

Leave a Reply

Your email address will not be published. Required fields are marked *