Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
SAFETY PRECAUTIONS
s7
WARNING
2. Absolute pulse coder battery replacement
When replacing the memory backup batteries, keep the power to the machine (CNC) turned on,
and apply an emergency stop to the machine. Because this work is performed with the power
on and the cabinet open, only those personnel who have received approved safety and
maintenance training may perform this work.
When replacing the batteries, be careful not to touch the highvoltage circuits (marked
and
fitted with an insulating cover).
Touching the uncovered highvoltage circuits presents an extremely dangerous electric shock
hazard.
NOTE
The absolute pulse coder uses batteries to preserve its absolute position.
If the battery voltage drops, a low battery voltage alarm is displayed on the machine operators panel,
CRT/MDI screen, or etc..
When a low battery voltage alarm is displayed, replace the batteries within a week. Otherwise, the
absolute position data held by the pulse coder will be lost.
To replace the battery, see the procedure described Maintenance Manual for FANUC CONTROL
MOTOR AMPLIFIER α series or FANUC SERVO MOTOR β series.

Leave a Reply

Your email address will not be published. Required fields are marked *