Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
1. DISPLAY AND OPERATION
67
Reset
Function
KEY
SW
SETTING
PWE=1
Mode
Function
key
Operation
Resetting the operating time _ POS [(OPRT)] [TIME: 0] [EXEC]
Resetting the number of
machined parts
_ POS [(OPRT)] [TIME: 0] [EXEC]
Resetting the OT alarm When the
power is on
_
P CAN
CRT/MDI
and
LCD with touch panel
Turn on the power while holding down
the topright corner of the screen.
Display the IPL screen, then
P [SELECT] [YES]
CAN [SELECT] [YES] [YES]
Resetting alarm 100 _ _
RESET
CAN
CRT/MDI
and
LCD with touch panel
SPCL CAN RESET
ENTER
Data input from the MDI
Function
KEY
SW
SETTING
PWE=1
Mode
Function
key
Operation
Inputting parameters f MDI or
emergency stop
SYSTEM
(PARAM)
Parameter No. [NO.SRH] Data
INPUT PWE = 0
INPUT
RESET
Inputting offset data OFF _ OFFSET Offset No. [NO.SRH] Offset
value INPUT
Inputting setting data OFF MDI SETTING
Setting No. [NO.SRH] Data INPUT
Inputting PMC parameters
(for the counter and data table)
OFF MDI or
emergency
stop
SYSTEM
(PMC)
[PMCPRM] [COUNTR] Data
[DATA]
INPUT
Inputting PMC parameters
(for the timer and keep relay)
f
[PMCPRM] [TIMER] Data
[KEEPRL]
INPUT
Tool length compensation JOG POS
OFFSET
POS (Display of relative coordinate system)
AXIS [ORIGN] OFFSET
More the tool measuvment position
Offset No. [NO.SRH] AXIS [C INPUT]
1.9
LIST OF
OPERATIONS
(SETTING AND
DISPLAY UNIT (CRT,
PDP, LCD, HANDY
OPERATORS PANEL,
AND LCD WITH
TOUCH PANEL))

Leave a Reply

Your email address will not be published. Required fields are marked *