Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
1. DISPLAY AND OPERATION
73
Switching of 1path mode (Power Mate iD) and 2path mode (Power Mate iD2)
Function
KEY
SW
SETTING
PWE=1
Mode
Function
key
Operation
From 1path mode to 2path
mode
When the
power is on
_
CRT/MDI
Turn on the power while holding down S and
2
LCD with touch panel
Turn on the power while holding down
the topright corner of the screen.
Display the IPL screen, then
S [SELECT] [YES]
1 [SELECT] [YES] [YES]
From 2path mode to 1path
mode
When the
power is on
_
CRT/MDI
Turn on the power while holding down S and
1
LCD with touch panel
Turn on the power while holding down
the topright corner of the screen.
Display the IPL screen, then
S [SELECT] [YES]
2 [SELECT] [YES] [YES]
NOTE
1 When this operation is performed, all CNC data including offset values and macro variables
stored in the batterypowered memory (SRAM) is cleared. The parameters are reset to the
factoryset values. So, the CNC data such as the parameters, offset values, and macro
variables needs to be set again.
2 Special parameters can not be cleared in this operation.
3 Path selection operation needs to be performed only once at the time of switching to path
control. Path selection operation need not be performed each time the power is turned on.
4 Even if the power is turned on again while the 1 and S keys are held down in the 1path
mode, or the power is turned on again while the 2 and S keys are held down in the 2path
mode, all SRAM data is cleared.
5 If a memory allclear operation is performed, the path selection data returns to the 1path mode
selection state.
Switching between the 1path mode and 2path mode (Power Mate iD2)
Function
KEY
SW
SETTING
PWE=1
Mode
Function
key
Operation
From 1path mode to 2path
mode
_
CRT/MDI
Press H and 2 simultaneously.
LCD with touch panel
SPCL H 2 ENTER
From 2path mode to 1path
mode
_
CRT/MDI
Press H and 1 simultaneously.
LCD with touch panel
SPCL H 1 ENTER

Leave a Reply

Your email address will not be published. Required fields are marked *