Fanuc Power Mate i-D/H Operation Maintenance Handbook

2. OPERATION LIST
81
Path control switching (PowerMate i–D)
When twopath control is switched to onepath control or vice versa, all
CNC data including parameters and programs is cleared. Parameters are
set again to factory settings. However, option parameters are not cleared.
Once path control is switched, the new setting remains effective even after
power is turned off. It does not need to be set at each power–up.
Function
KEY
SW
PWE
= 1
Mode
Function
key
Operation
From one
path con-
trol to two
path con-
trol
At pow-
er–up
OTHERS
[KEY CODE1] 2
[KEY CODE2] S
From two
path con-
trol to
one–path
control
At pow-
er–up
OTHERS
[KEY CODE1] 1
[KEY CODE2] S
Registration from NC tape
Function
KEY
SW
PWE
= 1
Mode
Function
key
Operation
One pro-
gram reg-
istration
f EDIT [F2] O Program No. [F7]
Plural pro-
gram reg-
istration
f EDIT [F2] O Program No. [F7]
Collation
of program
in memory
and NC
tape
EDIT [F2] [F7]

Leave a Reply

Your email address will not be published. Required fields are marked *