Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
96
Tape format PM i–D PM i–H
Hole position data
Drilling data
Number of repeat
Drilling mode
G73 X__Y__Z__P__Q__R__F__K__ ;
G74 X__Y__Z__P__Q__R__F__K__ ;
G76 X__Y__Z__P__Q__R__F__K__ ;
G78 X__Y__Z__Q__R__F__ ;
G79 X__Y__Z__Q__R__F__ ;
G81 X__Y__Z__P__Q__R__F__K__ ;
G82 X__Y__Z__P__Q__R__F__K__ ;
G83 X__Y__Z__P__Q__R__F__K__ ;
G84 X__Y__Z__P__Q__R__F__K__ ;
G85 X__Y__Z__P__Q__R__F__K__ ;
G86 X__Y__Z__P__Q__R__F__K__ ;
G87 X__Y__Z__P__Q__R__F__K__ ;
G88 X__Y__Z__P__Q__R__F__K__ ;
G89 X__Y__Z__P__Q__R__F__K__ ;
G80 ; Cancel
Gjj X__Y__Z__R__Q__P__F__K__ ;
f
Item Address Explanation
Drilling mode GVV G73, G74, G76, G78, G79, G80 to
G89
Hole position data X, Y Specifies the hole position by an in-
cremental or absolute value.
Drilling data Z Specifies the distance from point R to
the bottom of the hole.
R Specifies the distance from the initial
level to point R.
Q Specifies each cut-in value with G73
and G83 or the shift value with G76
and G87. (Always specified with an
incremental value.)
Specifies the hole position, at which
control between chasers is performed
by G78 and G79, using the distance
from the bottom of the hole.
P Specifies the dwell time at the bottom
of the hole.
F Specifies the feed rate.
Number of repeats K Specifies the number of repeats for a
series of operation 1 to 6.

Leave a Reply

Your email address will not be published. Required fields are marked *