Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
118
Display of the items on the diagnostic screen (for the DPL/
MDI operation package only)
DGN
number
Description Unit
800 Relative coordinates Least input increment
801 Skip position Least input increment
802 Remaining travel distance Least input increment/2
803 Accumulated acceleration/de-
celeration amount
End position in previous
block
804 End point position of the pre-
vious block
Least input increment/2
810 No. of program under execu-
tion
811 No. of sequence under execu-
tion
820 G code in group 01
821 G code in group 02
822 G code in group 03
823 G code in group 05
824 G code in group 06
825 G code in group 09
827 G code in group 10
830 F code under execution 0.001 mm/min
0.00001 inch/min
(For a command without
a decimal point
1 mm/min
0.01 inch/min)
831 Actual feedrate mm/min
deg/min
0.01 inch/min
832 Actual spindle speed min
–1
PM i–D
833 Value resulting from compen-
sating the value input with the
analog input function
10 mV
840 Number of registered programs Number of programs
841 Number of programs used Number of characters
850 ROM series number of NC sys-
tem
851 ROM edition number of NC
system
852 Operation mode
853 ROM series number of servo
system
854 ROM edition number of servo
system
855 ROM series number of PMC
system
856 ROM edition number of PMC
system
857 Ladder program number
858 Ladder program edition number
NOTE Item No. 832, actual spindle speed, is displayed on the PM iD only.

Leave a Reply

Your email address will not be published. Required fields are marked *