Fanuc Power Mate i-D/H Operation Maintenance Handbook

6. STATUS DISPLAY BY SELFDIAGNOSTIC DISPLAY
125
6.4 Interface between CNC and PMC/MT and
Displaying I/O Signals
(1) Power Mate iD (onepath control) or Power Mate i–H
Addresses of interface signals between CNC and PMC/MT.
Y000X
X000X
F000X
G000X
CNC MTPMC
(2) Power Mate iD (twopath control)
The figure below shows the addresses of the interface signals between
the CNC and the PMC.
Note, however, that some of signals common to paths 1 and 2 are
allocated to path 1.
Y000X
X000X
G1000X
F1000X
G000X
F000X
CNC MTPMC
Path 1
Path 2

Leave a Reply

Your email address will not be published. Required fields are marked *