Fanuc Power Mate i-D/H Operation Maintenance Handbook

6. STATUS DISPLAY BY SELFDIAGNOSTIC DISPLAY
147
6.4.2 Address list
The address relationships between the Power Mate iMODEL D/H and
PMC interface signals are shown below. (Twopath control is effective to the
Power Mate iD only.)
Path 1 side of one–path
and twopath control
G000 to
Path 2 side of two
path control
G1000 to
Path 1 side of one–path
and twopath control
F000 to
Path 2 side of two
path control
F1000 to
CNC PMC MT
X000 to /X1000 to
Y000 to /Y1000 to
The details of the Power Mate iMODEL D/H and PMC interface signals are
listed below. In the list, #D represents signals dedicated to the Power Mate
iMODEL D, #D1 represents those dedicated to onepath control, #D2
represents those dedicated to twopath control, and #H represents those
dedicated to the Power Mate iMODEL H. The G/F addresses in path 2 side
of twopath control are equivalent to those in path 1 plus 1000. The signals
common to both paths are arranged on the path 1 side.
In the list, #1 represents signals dedicated to path 1, while #2 represents
signals dedicated to path 2.
Example
#7 #6 #2 #1 #0
G005
AFL SFIN#D MFIN
MTPMC
F Power Mate i–D
#7 #6 #5 #4 #3 #2 #1 #0
X000
SKIP#1 *RILK#1 *DEC#1 *ESP#1 ESKIP#1 SKIP4#1 SKIP3#1 SKIP2#1
X001
SKIP#2 *RILK#2 *DEC#2 *ESP#2 SKIP4#2 SKIP3#2 SKIP2#2
Built–in I/O is used
#7 #6 #5 #4 #3 #2 #1 #0
X1000
SKIP#1 *RILK#1 *DEC#1 *ESP#1 ESKIP#1 SKIP4#1 SKIP3#1 SKIP2#1
X1001
SKIP#2 *RILK#2 *DEC#2 *ESP#2 SKIP4#2 SKIP3#2 SKIP2#2
#7 #6 #5 #4 #3 #2 #1 #0
Address Bit No.
F Power Mate i–H
X000
SKIP *RILK *ESP ESKIP SKIP4 SKIP3 SKIP2
X001
X002
*DEC8 *DEC7 *DEC6 *DEC5 *DEC4 *DEC3 *DEC2 *DEC1

Leave a Reply

Your email address will not be published. Required fields are marked *