Fanuc Power Mate i-D/H Operation Maintenance Handbook

7. HARDWARE
181
7.5.6 High–speed serial bus (HSSB) board
D Specification
Name
Printed–circuit board
specification
High–speed serial bus (HSSB) board A20B–8001–0730
D Connector and LED locations
Connector for
connection with
the backpanel,
JNA
High–speed
serial bus set-
ting switch,
SW1
At maintenance: 0
Usually: 1
LED B
LED A
LED 4
LED 3
LED 2
LED 1
High–speed
serial bus (HSSB)
connector, COP7
Name Color Meaning Required action
LED B Red HSSB–based com-
munication has
been interrupted.
Check the HSSB cable.
Check the PC or intelligent termi-
nal status.
Replace the printedcircuit board.
LED A Red A RAM parity alarm
occurred in the
common RAM.
If this LED is on, replace the printed
circuit board though the alarm can
sometimes be released by turning
the power off then on.
Green LED status display J : on and j : off
4 3 2 1
Status
J J J J The power has just been switched on.
J J J j The HSSB board is being initialized.
J J j J The HSSB is waiting for the PC to complete booting.
J J j j The CNC screen is displayed on the PC.
J j j j Start–up has been completed normally, and the regular operation
is under way.
j J J j A thermal error has been detected at the intelligent terminal.
j J j J HSSB–based communication has been interrupted.
j J j j A RAM parity alarm condition has occurred in the common RAM.
j j J J A communication error has occurred.
j j J j A battery alarm condition has occurred at the intelligent terminal.

Leave a Reply

Your email address will not be published. Required fields are marked *